You can operate the device when the engine is
running or when the ignition is switched on.
If you have any additional questions,
please contact your BMW center.<
If the device fails to function even after
repeated programming, check whether
Deleting all stored programs
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button 1 of the integrated universal remote
control. If the LED 2 on the integrated universal
remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons 1 as described at Alternating-code
hand-held transmitters.<
Press the left and right-hand memory button 1
for approx. 20 seconds until the LED 2 flashes.
All stored programs are deleted.
Individual programs cannot be deleted.
Rememorizing individual programs
1.
Hold the original hand-held remote control
approx. 4 in/10 cm to 12 in/30 cm away
from the memory buttons 1.
The required distance between the
hand-held transmitter and the mem-
ory buttons 1 depends on the relevant sys-
tem of the original hand-held transmitter
used.<
Alternating-code hand-held
transmitters
2.
3.
Press the desired memory button 1 of the
integrated universal remote.
To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:
If the LED 2 flashes slowly after approx.
20 seconds, press the command button of
the original hand-held transmitter. As soon
as the LED 2 flashes rapidly, release both
buttons. If the LED 2 does not flash rapidly
after approx. 15 seconds, alter the distance
and repeat the step.
Programming will be easier with the aid of
a second person.<
Glove compartment
1.
2.
Park your vehicle within the range of the
remote-controlled device.
Opening
Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.
3.
4.
Locate the button on the receiver of the
device to be set, e.g. on the drive unit.
Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button 1
of the integrated universal remote control
three times.
Press the button. The glove compartment
opens automatically and the lamps come on.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
To prevent injury in the event of an acci-
dent while the vehicle is being driven,
110
Online Edition for Part no. 01 41 2 602 716 - © 08/09 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 650i, BMW E63, BMW E64 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.