2011 Hyundai Genesis Owners Manual

Features of your vehicle
Gate  operator  &  Canadian  program-
ming
Reprogramming  a  single  HomeLink
button
®
Erasing HomeLink  buttons
®
Individual   buttons   cannot  be   erased.
However, to erase  all three programmed
buttons:
During   programming,    your   handheld
transmitter may automatically stop trans-
mitting. Continue to press  the Integrated
To program a new device  to a previously
button,  follow  these
trained  HomeLink
steps:
®
1. Press
and
hold
the
two
outer
HomeLink
®
Wireless Control System but-
1. Press and hold the desired HomeLink®
button.  Do NOT  release  until  step  4
has been completed.
When the indicator light begins to flash
slowly (after 20 seconds),  position the
handheld  transmitter   1  to  3   inches
HomeLink®  buttons until  the  indicator
light begins to flash-after 20 seconds.
ton   (note  steps   2   through   4  in   the
Standard  Programming  portion   of  this
document) while you  press and re-press
2.
Release both  buttons. Do not hold  for
longer than 30 seconds.
2.
("cycle")
your handheld transmitter every
The   Integrated    HomeLink ®
Wireless
two  seconds  until the  frequency  signal
has been learned. The indicator  light will
flash slowly and then  rapidly after sever-
al seconds upon successful training.
Control  System  is  now  in  the   training
(learn) mode and can be programmed at
any time  following the appropriate  steps
in the Programming sections above.
away from the HomeLink
Press and hold the handheld transmit-
ter  button.  The  HomeLink
®
surface.
3.
®
indicator
light will flash, first slowly and then rap-
idly.
4. When the indicator light begins to flash
rapidly, release both buttons.
Operating HomeLink
To operate, simply press and release the
®
programmed
HomeLink
®
button.
Activation will  now occur  for the  trained
device  (i.e.  garage   door  opener,  gate
operator,  security   system,   entry  door
lock, home/office  lighting, etc.). For con-
venience,  the  hand-held  transmitter   of
the device may also be used at any time.
5.
Press
and    hold    the   just-trained
®
HomeLink  button and observe the red
Status  Indicator  LED. If  the  indicator
light stays on constantly, programming
is   complete   and  your   new   device
should activate.
4
44
Product Specification
Categories Hyundai Manuals, Hyundai Genesis, Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 409 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Genesis
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field