Features
266
i The distance between garage door
remote controlA and the integrated
garage door opener depends on the system
of the garage door drive. You might require
several attempts. You should test every
position for at least 20 seconds before
trying another position.
of the garage door. People could otherwise be
injured by the movement of the door.
X Keep transmitter buttonB on garage door
remote controlA pressed until indicator
lamp: starts to flash rapidly.
The programming has been successful if
indicator lamp: flashes rapidly.
X Release transmitter buttons;,= or?
Remote control in the rear-view mirror
on the integrated remote control or
transmitter button on the garage door
remote controlB.
Garage door remote controlA is not part of
the garage door opener.
i To achieve the best result, insert new
batteries in garage door remote control
A of your garage door drive before
programming.
If indicator lamp: goes out after
approximately 20 seconds and has not
flashed rapidly:
X Release transmitter buttons;,= or?
X Erase the memory of the integrated remote
control (Y page 268) before programming
it for the first time.
on the integrated remote control or
transmitter button on the garage door
remote controlB.
X Turn the SmartKey to position 2 in the
ignition lock.
X Press and hold one of transmitter
buttons; to? on the integrated remote
control.
X Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.
After a short time, indicator lamp: will
start flashing. It flashes about once per
second.
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
i Indicator lamp: flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp: will only start flashing at a rate of
once per second after 20 seconds have
elapsed.
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
X Keep the transmitter button depressed.
X Point transmitter buttonB of garage door
remote controlA towards the transmitter
buttons on the rear-view mirror from a
distance of 2 to 12 inches (5 to 20 cm).
Notes on programming the remote
control
Canadian radio frequency laws require
transmitter signals to "time-out" (or quit) after
several seconds of transmission. This may
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes Benz C207, Mercedes Benz E350 BlueTEC, Mercedes-Benz E350, Mercedes-Benz E550, Mercedes-Benz W212 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 5)
Automotive readers have rated 2011 Mercedes-Benz E350 E350 BlueTEC E550 W212 C207 Coupe Owners Manual 4.0 out of 5.0 based on 2 product reviews. excellent car.
few limited issues
Very good. Very good. Very good.