J94S.book Page 15 Saturday, June 23, 2001 1:04 PM
Maintenance and Care
Owner Maintenance
5.
Fill the radiator (to the top of the filler
neck) and then the coolant reservoir (to
F) with as much ethylene-glycol-based
coolant and water as necessary to
provide protection from freezing and
corrosion.
In extremely cold climates, add the
amount recommended by the coolant
manufacturer.
Brake/Clutch Fluid
wInspecting Brake/Clutch Fluid
Level
The brakes and clutch draw fluid from the
same reservoir.
Inspect the fluid level in the reservoir
regularly. It should be kept at MAX.
The level normally drops with
accumulated distance, a condition
associated with wear of brake and clutch
linings. If it is excessively low, have the
brake/clutch system inspected by an
Authorized Mazda Dealer.
6.
7.
Reinstall the cooling system cap.
Run the engine at idle for about 10
minutes.
8.
Then do this:
•
Run the engine at 2,500 rpm for
about 5 minutes.
•
Increase the engine speed to 3,000
rpm for about 5 seconds and then
release the accelerator.
•
•
Do this 4 or 5 times.
Make sure the engine temperature
gauge does not reach the HOT zone.
After turning off the engine, inspect the
drain plug and the water hoses for leaks.
9.
After the engine has cooled, remove
the cooling system cap and inspect the
coolant level. If it’s low, repeat steps 5
to 8.
Because this procedure requires technical
expertise, we recommend that it be done
by an Authorized Mazda Dealer.
NOTE
Mixing green coolant with orange
coolant could decrease the service life
expectancy of the coolant. Use only
genuine Mazda orange colored or
equivalent coolant.
8-15
Form No. 8Q50-EA-01G
| Categories | Mazda 626 Manuals |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)