DRIVING YOUR HYUNDAI
(
8) For speedometer test or inspection/mainte-
nance (I/M) program of full-time 4WD ve-
hicle, use a four-wheel chassis dynamom-
eter.
Driving on dry paved road and high-
Driving in Water
Select the LOW mode and drive through slowly.
way
Select the AUTO to drive on dry paved roads.
Especially on dry highway, never select the
LOW.
CAUTION:
Never engage the parking brake whilst per-
forming these tests.
Driving on snowy or icy roads
Select the AUTO or LOW in accordance with
the road conditions, and then gradually depress
the accelerator pedal for a smooth start.
o
In rare cases when it's unavoidable that a
4WD vehicle is to be inspected for speed-
ometer test on 2WD roll tester, strictly follow
the procedures next.
40 cm
Driving on sandy or muddy roads
Select the LOW and then gradually depress the
accelerator pedal for a smooth start. Keep the
pressure on the accelerator pedal constant as
possible, and drive at low speed.
1.
Check the tyre pressures recommended
for your vehicle.
D090E01HP
2.
Place the rear wheels on the roll tester
for speedometer test as shown in the
illustration.
The maximum advisable wading depth is ap-
proximately 40cm.
Climbing sharp grades
Select the LOW to maximize use the engine
torque.
Before driving through water, such as when
crossing shallow streams, first check the depth
of the water and the bottom of the river bed for
firmness. Drive slowly at the speed of 3mph
(5 km/h) and avoid deep water.
Take all necessary safety measures to ensure
that water damage to the engine or other ve-
hicle parts does not occur.
3.
4.
Release the parking brake.
Place the front wheels on the temporary
free roller as shown in the illustration.
Descending sharp grades
Select the LOW, use the engine brake and
descend slowly.
WARNING:
Keep away from the front of the vehicle
whilst inspecting. This is very dangerous as
the vehicle can jump forward and cause
serious injury or death.
Water entering the engine air intake will cause
severe engine damage.
Water can wash the grease from wheel bear-
ings, causing rusting and premature failure, and
may also enter the axles, transmission and
transfer case, reducing the gear oil's lubricating
qualities.
(9)
When using tyre chains, always attach them
to the rear wheels.
If the front or rear wheels get stuck in the
mud, do not spin them recklessly. The
4WD system could be damaged.
(10)
2-
13
Product Specification
Categories | Hyundai Manuals, Hyundai Terracan Manuals |
---|---|
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, Terracan |
Document File Type | |
Copyright | Attribution Non-commercial |