3
IN CASE OF EMERGENCY
8
ZD070F1-E
3. Loosen Wheel Nuts
D060E01A-AAT
4. Put the Jack in Place
SD070G1-E
5. Raising the Car
Wrench bar
Wheel
nut
wrench
HFC4022
HGK4013
HGK4012
The wheel nuts should be loosened
slightlybeforeraisingthecar.Toloosen
the nuts, turn the wrench handle coun-
terclockwise.Whendoingthis,besure
that the socket is seated completely
over the nut so it cannot slip off. For
maximum leverage, position the
wrench so the handle is to the right as
shown in the drawing. Then, whilst
holding the wrench near the end of the
handle, pull up on it with steady pres-
sure. Do not remove the nuts at this
time. Just loosen them about one-half
turn.
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the illustra-
tion.
After inserting a wrench bar into the
wheel nut wrench, install the wrench
bar into the jack as shown in the draw-
ing. As the jack begins to raise the
vehicle,doublecheckthatitisproperly
positioned and will not slip. If the jack
is on soft ground or sand, it may be
necessary to place a stout piece of
timber under the base of the jack to
prevent it from sinking.
Raise the car high enough so that the
fully inflated spare tyre can be in-
stalled.
| Categories | Hyundai Manuals, Hyundai Coupe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Coupe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)