Controls in detail
Useful features
Step 3:
i
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
If the indicator lamp 1 flashes rapidly
for about two seconds and then turns
to a constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.
̈
Hold the end of the hand-held remote
control transmitter 6 of the device
you wish to train approximately 2 to
5
in (5 to12 cm) away from the surface
of the integrated remote control
located on the interior rear view mirror,
keeping the indicator lamp 1 in view.
20 seconds.
Step 5:
Step 4:
Step 7:
̈
When the indicator lamp 1 flashes
rapidly, release both buttons.
̈
Using both hands, simultaneously
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
press the hand-held transmitter
button 5 and the desired integrated
signal transmitter button (2, 3
or 4). Do not release the buttons until
completing step 5.
Step 6:
̈
Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp 1.
The indicator lamp 1 on the
integrated remote control will flash,
first slowly and then rapidly.
If the indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.
233
Product Specification
Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
---|---|
Tags | Mercedes-Benz C-Class, Mercedes-Benz C230, Mercedes-Benz C240, Mercedes-Benz C32 AMG, Mercedes-Benz C320, Mercedes-benz W203 |
Model Year | 2004 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
It is a good reference material specially if you bought the car second hand