Practical hints
Flat tire
When changing wheel on a hill:
The jack take-up brackets are located di-
rectly behind the front wheel housing and
in front of the rear wheel housing.
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Be sure that the jack arm is
fully seated in the jack take-up bracket. Al-
ways lower the vehicle onto sufficient ca-
pacity jackstands before working under the
vehicle.
̈
Place chocks on the downhill side
blocking both wheels of the other axle.
̈
Take the two-piece wheel wrench and
the jack out of the trunk (୴ page 352).
Assemble wheel wrench.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into either side of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
1 Jack take-up bracket
2 Jack
3 Crank
̈
Position jack 2 on firm ground under
the respective jack take-up bracket 1.
̈
On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
371
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E500, Mercedes-Benz E55 AMG, Mercedes-Benz W211 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Automotive readers have rated 2004 Mercedes-Benz E-Class Operators Manual E320 4MATIC E500 E55 AMG 2.0 out of 2.0 based on 1 product reviews. Am looking for years 2004 e200 . Can you please support?