Controls in detail
Useful features
Step 3:
i
i
The indicator lamp 4 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.
If the indicator lamp 4 blinks rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the “rolling code” feature.
̈
Hold the end of the hand-held remote
control transmitter 6 of the device
you wish to train approximately 2 to
5
in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp 4 in view.
Step 5:
Step 7:
Step 4:
̈
When the indicator lamp 4 flashes
rapidly, release both buttons.
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
̈
Using both hands, simultaneously
press the hand-held transmitter
button 5 and the desired integrated
signal transmitter button (1, 2
or 3). Do not release the buttons until
completing step 5.
Step 6:
̈
Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp 4.
The indicator lamp 4 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
If the indicator lamp 4 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.
155
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SLK-Class Manuals |
|---|---|
| Tags | Mercedes-Benz SLK230, Mercedes-Benz SLK32 AMG, Mercedes-Benz SLK320 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)