VEHICLE MAINTENANCE REQUIREMENTS 5- 9
F070E03A-AAT
o Automatic transaxle fluid
6ZF070H1-A
o Rear brake drums and linings/
parking brake
6ZF070L1-A
o Suspension mounting bolts
The fluid level should be in the "HOT"
range of the dipstick, after engine and
transaxle are at normal operating tem-
perature. Check the Automatic
Transaxle Fluid level with the engine
running and the transaxle in neutral,
with the parking brake properly ap-
plied. Use DIAMOND ATF SP-III or
SK ATF SP-III when adding or chang-
ing fluid.
Check the suspension connections
for looseness or damage. Retighten
to the specified torque.
Check the rear brake drums and lin-
ings for scoring, burning, leaking fluid,
broken parts, and excessive wear.
Inspect the parking brake system in-
cluding the parking brake lever and
cables. For detailed service proce-
dures, refer to the Shop Manual.
6ZF070M1-A
o Steering gear box, linkage &
boots/lower arm ball joint
With the vehicle stopped and engine
off, check for excessive freeplay in
the steering wheel.
Check the linkage for bends or dam-
age. Check the dust boots and ball
joints for deterioration, cracks, or dam-
age. Replace any damaged parts.
6ZF070J1-A
o Brake pads, calipers and
rotors
6ZF070F1-A
o Brake hoses and lines
Visually check for proper installation,
chafing, cracks, deterioration and any
leakage. Replace any deteriorated or
damaged parts immediately.
Check the pads for excessive wear,
discs for run out and wear, and cali-
pers for fluid leakage.
6ZF070N1-A
o Powersteeringpump,beltand
hoses
6ZF070K1-A
o Exhaust pipe and muffler
6ZF070G2-A
o Brake fluid
Check the power steering pump and
hoses for leakage and damage. Re-
place any damaged or leaking parts
immediately. Inspect the power steer-
ing belt for evidence of cuts, cracks,
excessive wear, oiliness and proper
tension. Replace or adjust it if neces-
sary.
Visually inspect the exhaust pipes,
muffler and hangers for cracks, dete-
rioration, or damage. Start the engine
and listen carefully for any exhaust
gas leakage. Tighten connections or
replace parts as necessary.
Check brake fluid level in the brake
fluid reservoir. The level should be
between "MIN" and "MAX" marks on
the side of the reservoir. Use only
hydraulic brake fluid conforming to
DOT 3 or DOT 4.
| Categories | Hyundai Manuals, Hyundai Getz Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Getz |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)