Maintenance
G201005AUN-UK
G201007AUN-UK
WARNING - Tyre age
5. Maximum permissible inflation
pressure
7. Uniform tyre quality grading
Tread wear
Tyres degrade over time, even
when they are not being used.
Regardless of the remaining
tread, it is recommended that
tyres generally be replaced
after six (6) years of normal
service. Heat caused by not cli-
mates or frequent high loading
conditions can accelerate the
aging process. Failure to follow
this Warning can result in sud-
den tyre failure, which could
lead to a loss of control and an
This number is the greatest amount The tread wear grade is a compara-
of air pressure that should be put in tive rating based on the wear rate of
the tyre. Do not exceed the maximum the tyre when tested under controlled
permissible inflation pressure. Refer conditions on a specified govern-
to the Tyre and Loading Information ment test course. For example, a tyre
label for recommended inflation graded 150 would wear one-and-a-
pressure.
half times (1½) as well on the gov-
ernment course as a tyre graded
100.
G201006AUN-UK
6.
Maximum load rating
The relative performance of tyres
This number indicates the maximum depends upon the actual conditions
load in kilograms and pounds that of their use, however, and may
can be carried by the tyre. When depart significantly from the norm
replacing the tyres on the vehicle, because of variations in driving
always use a tyre that has the same habits, service practices and differ-
load rating as the factory installed ences in road characteristics and cli-
accident involving
injury or death.
serious
G201004AUN-UK
tyre.
mate.
4.
Tyre ply composition and material
These grades are molded on the
side-walls of passenger vehicle
tyres.The tyres available as standard
or optional equipment on your vehi-
cles may vary with respect to grade.
The number of layers or plies of rub-
ber-coated fabric are in the tyre. Tyre
manufacturers also must indicate the
materials in the tyre, which include
steel, nylon, polyester, and others.
The letter "R" means radial ply con-
struction; the letter "D" means diago-
nal or bias ply construction; and the
letter "B" means belted-bias ply con-
struction.
7
40
| Categories | Hyundai Manuals, Hyundai i30 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, i30 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)