Controls in detail
Useful features
୴
୴
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
Indicator lamp 1 will flash, first slowly
and then rapidly.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health.
All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.
i Indicator lamp 1 flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Programming integrated remote con-
trol
Step 5:
̈
After indicator lamp 1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
Step 3:
Step 1:
Switch on the ignition (୴ page 82).
Step 2:
̈
Hold the end of hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
̈
Step 6:
̈
If you have previously programmed a
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or 4) to be pro-
grammed, while keeping indicator
lamp 1 in view.
̈
Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe indicator lamp 1.
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If indicator lamp 1 stays on
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons 2 and 4 and release
them only when indicator lamp 1 be-
gins to flash after approximately
Step 4:
constantly, programming is complete
and your device should activate when
the respective signal transmitter
̈
Using both hands, simultaneously
press hand-held remote control
button 6 and the desired signal trans-
mitter button (2, 3 or 4). Do not
release the buttons until step 5 is com-
pleted.
button (2, 3 or 4
leased.
) is pressed and re-
20
seconds (do not hold the button for
304
| Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz C230, Mercedes-Benz C300, Mercedes-Benz C350, Mercedes-benz W203 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.75 out of 5)
Automotive readers have rated 2008 Mercedes-Benz C-Class Operators Manual C230 C300 C350 Sport 4MATIC 4.8 out of 5.0 based on 4 product reviews. nominated as the best hip hop artist in SA 2015.
-was formally in a group known as teargas
-what is caracara about… what was the role like of the
This item is very good.
I hope it will be good to me.
Thanks.
lost, damage , Operator’s Manual 10
Greate! Place to get ibfo on your Mercedes!