Useful features
174
X Step 12: Confirm the garage door
operation by pressing the programmed
signal transmitter button (;,= or?).
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
X Step 13: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
Reprogramming a single signal
transmitter button
To program a device using a signal
transmitter button previously trained, follow
these steps:
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission which
may not be long enough for the integrated
signal transmitter to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
X Switch on the ignition.
X Press and hold the desired signal
transmitter button (;,= or?). Do not
release the button.
Indicator lamp: will begin to flash after
20 seconds.
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
Operation of integrated remote control
X Step 4: Press and hold the signal
transmitter button (;,= or?). Do not
release this button until it has been
successfully trained.
X While still holding down the signal
transmitter button (;,= or?), “cycle”
your hand-held remote control buttonB
as follows: Press and hold buttonB for
X Switch on the ignition.
X Select and press the appropriate
integrated signal transmitter button (;,
=
or?) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
2
seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator
lamp: will flash slowly and then rapidly
after several seconds.
Erasing the integrated remote control
memory
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons; and?, for
approximately 20 seconds, until indicator
lamp: flashes rapidly. Do not hold for
longer than 30 seconds.
X Proceed with programming step 5 and
step 6 to complete.
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
The codes of all three channels are erased.
programming of an integrated remote
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SL-Class Manuals |
|---|---|
| Tags | Mercedes Benz SL63 AMG, Mercedes-Benz R230, Mercedes-Benz SL550, Mercedes-Benz SL600, Mercedes-Benz SL65 AMG |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4 out of 4)
Automotive readers have rated 2011 Mercedes-Benz SL550 SL600 SL63 AMG SL65 AMG SL600 SL65 AMG R230 Owners Manual 4.0 out of 4.0 based on 3 product reviews.