Flat tire
278
X Press on both clips; simultaneously to
release buckle:.
Never start the engine when the vehicle is
raised.
X Store the tensioning straps in a safe place.
You will need them to store the spare wheel
in the trunk after use (Y page 225).
Also observe the notes on the jack.
X Prevent the vehicle from rolling away by
blocking wheels with wheel chocks (not
included) or other sizeable objects.
Lifting the vehicle
G Warning!
When changing a wheel on a level surface:
X Place a wheel chock or other sizeable
object in front of and another wheel chock
or other sizeable object behind the wheel
that is diagonally opposite to the wheel
being changed.
When jacking up the vehicle, only use the jack
which has been specifically approved by
Mercedes-Benz for your vehicle.
The jack is designed exclusively for jacking up
the vehicle at the jack tubes built into both
sides of the vehicle. Make sure the jack arm
is fully inserted in the jack tube. The jack must
always be vertical when in use, especially on
inclines or declines.
Always try lifting the vehicle using the jack on
a level surface. However, should
circumstances require you to do so on a hill:
X Place wheel chocks or other sizeable
objects on the downhill side in front of both
wheels on the side opposite to the side on
which the wheel is to be changed.
The jack is intended only for lifting the vehicle
briefly for wheel changes. It is not suited for
performing maintenance work under the
vehicle. To help avoid personal injury, use the
jack only to lift the vehicle during a wheel
change.
G Warning!
Only jack up the vehicle on level ground or on
slight inclines/declines. Otherwise, the
vehicle could fall off the jack and injure you or
others.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always lower the vehicle onto sufficient
capacity jackstands before working under the
vehicle.
Always engage the parking brake firmly and
block the wheels with wheel chocks or other
sizeable objects before raising the vehicle
with the jack. Do not disengage the parking
brake while the vehicle is raised.
Make sure that the ground on which the
vehicle is standing and where you place the
jack is solid, level and not slippery. If
necessary, use a large underlay. On slippery
surfaces, such as tiled floors, you should use
a non-slip underlay, for example a rubber mat.
X On the wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench:).
Do not use wooden blocks or similar objects
to support the jack. Otherwise the jack may
not be able to achieve its load-bearing
capacity if it is not at its full height.
The jack support tubes are located directly
behind the front wheel housings and in front
of the rear wheel housings.
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SL-Class Manuals |
|---|---|
| Tags | Mercedes Benz SL63 AMG, Mercedes-Benz R230, Mercedes-Benz SL550, Mercedes-Benz SL600, Mercedes-Benz SL65 AMG |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4 out of 4)
Automotive readers have rated 2011 Mercedes-Benz SL550 SL600 SL63 AMG SL65 AMG SL600 SL65 AMG R230 Owners Manual 4.0 out of 4.0 based on 3 product reviews.