Safety system of your vehicle
OLMB033044
OLMB033045
OLMB033046
Installing a child restraint with a
lap/shoulder belt
To install a child restraint system on
the rear seats, do the following:
2. Fasten the lap/shoulder belt latch 3. Remove as much slack from the
into the buckle. Listen for the dis-
belt as possible by pushing down
tinct “click” sound.
on the child restraint system while
feeding the shoulder belt back into
the retractor.
1.
Place the child restraint system on ✽ NOTICE
4.
Push and pull on the child restraint
system to confirm that the seat belt
is holding it firmly in place.
a rear seat and route the lap/shoul-
der belt around or through the
restraint, following the restraint
manufacturer’s instructions.
Position the release button so that it
is easy to access in case of an emer-
gency.
If your CRS manufacturer instructs or
recommends you use a ISOFIX top-
tether anchorage with the lap/shoul-
der belt, see page 2-45.
Be sure the seat belt webbing is not
twisted.
✽ NOTICE
When using the rear center seat belt,
you should also refer to “3-point Rear
Center Seat Belt” in this chapter.
To remove the child restraint, press
the release button on the buckle and
then pull the lap/shoulder belt out of
the restraint and allow the seat belt
to retract fully.
2-50
| Categories | Hyundai Manuals, Hyundai Tucson Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tucson |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)