Engine Oil
Refill
Clean the oil drain plug and its mating surface
on the engine sump. Fit the drain plug,
complete with a new copper washer, and
tighten to 13 lbf.ft (17 Nm).
Refill the engine with fresh oil, suitable for the
climatic conditions in which the vehicle is to be
operated (see ‘LUBRICANTS AND FLUIDS’,
page 271).
DO NOT overfill the engine! Remember that a
little oil will always remain in the engine after
draining and that, therefore, the quantity of oil
required to refill the engine will be slightly less
than the full capacity quoted in ‘CAPACITIES’,
page 272.
After filling, allow a few minutes to elapse
before checking the level on the dipstick (this
will allow all the oil to drain into the sump and
enable a true reading to be obtained). Once the
correct level of oil is shown on the dipstick,
replace the filler cap.
H4685
Start and run the engine. Do not rev the engine
until the oil pressure warning light
extinguishes. Check for oil leaks around the
drain plug.
Remove the drain plug and copper washer and
allow the engine oil to drain into the container.
WARNING
Oil from the engine can be very hot, to avoid
harmful burns, take care when removing the
drain plug.
Stop the engine, wait a few minutes, then check
the oil level and top up if necessary.
202
| Categories | Land Rover, Land Rover Discovery |
|---|---|
| Tags | Land Rover |
| Model Year | 2003 |
| Download File |
|
| Language | English |
| Product Name | Range Rover |
| Product Brand | Land Rover |
| Fuel Type | Gasoline / Petrol |
| Engine Oil Type | 0W/30, 0W/50, 5W/30 or 5W/40 oil meeting API service level SJ/CD, EC11 and having a viscosity band recommended for the temperature range of your locality |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)