Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position U, the locator lighting fea-
ture is activated, and the vehicle is un-
locked by remote control:
̈
Move the selection marker with
the æ or ç button to the LIGHT-
ING submenu.
ț
Parking lamps and low beam head-
lamps
̈
Press button j or k repeatedly
until you see this message in the dis-
play: LIGHT CIRCUIT HEADLAMP MODE .
ț
ț
ț
ț
Parking lamps
Tail lamps
ț
License plate lamps (in low ambient
light conditions)
The selection marker is on the current
setting.
License plate lamps
Front fog lamps
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
To activate locator lighting:
̈
Make sure the function LOCATOR
LIGHTING is set.
For safety reasons, resetting the
LIGHTING submenu to factory settings
̈
Turn the exterior lamp switch to
position U.
(
୴ page 152) while driving will not re-
̈
Press æ or ç to select manual
or daytime running lamp (constant)
mode. This function is not available in
countries where daytime running
lamps are mandatory.
set the daytime running lamp mode.
The locator lighting switches off when the
driver’s door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
In the display you will then see the mes-
sage: LIGHTING – CANNOT BE RESET
COMPLETELY TO FACTORY SETTINGS
WHILE DRIVING.
156
| Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
|---|---|
| Tags | Mercedes-Benz S430, Mercedes-Benz S500, Mercedes-Benz S55, Mercedes-Benz S600 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)