Getting started
Driving
Wiping with windshield washer fluid
!
ț
turn off the engine by pressing the
KEYLESS-GO* start/stop button
and open the driver’s door (with the
driver’s door open, starter switch is
in position 0, same as with
SmartKey removed from starter
switch)
Do not leave windshield wipers in inter-
mittent setting when vehicle is taken to
an automatic car wash or during wind-
shield cleaning. Wipers will operate in
the presence of water sprayed on the
windshield, and wipers may be dam-
aged as a result.
Press switch in the direction of
̈
arrow 1 past the resistance point.
The windshield wiper operates with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
before attempting to remove any block-
age.
The switch should not be left in inter-
mittent setting as the wipers will wipe
the windshield once every time the en-
gine is started. Dust that accumulates
on the windshield might scratch the
glass and/or damage the wiper blades
when wiping occurs on a dry wind-
shield.
(
୴ page 281).
ț
ț
Remove blockage.
!
Turn the windshield wipers on
again.
If anything blocks the windshield wip-
ers (leaves, snow, etc.), switch them off
immediately.
If windshield wipers fail to function at
all in switch position I,
ț
For safety reasons,
ț
ț
set the combination switch to the
next highest wiper speed
ț
turn off the engine by turning
the SmartKey to position 0 and
withdraw SmartKey from starter
switch
Single wipe
have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center
̈
Press switch briefly in the direction of
arrow 1.
or
The windshield wipers wipe one time
without washer fluid.
49
| Categories | Mercedes-Benz Manuals, Mercedes-Benz S-Class Manuals |
|---|---|
| Tags | Mercedes-Benz S430, Mercedes-Benz S500, Mercedes-Benz S55, Mercedes-Benz S600 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)