Integrated universal remote control*
115n
4.
Simultaneously press the transmit
If the LED 2 on the integrated universal
button on the original hand-held
transmitter and the desired memory
button 1 of the integrated universal
remote control. The LED 2 flashes
slowly at first. As soon as the LED 2
remote control flashes quickly for a
brief period and then remains lit up for
approx. two seconds, this indicates that
the original hand-held transmitter is
equipped with an alternating code. In
flashes rapidly, release both buttons. the case of an alternating-code system,
If the LED 2 does not flash rapidly
after approx. 15 seconds, alter the
distance.
program the memory buttons 1 as
described in the section on alternating-
code hand-held transmitters.
5.
To program other original hand-held
transmitters, repeat steps 3 and 4.
If you have additional questions, please
consult your BMW Sports Activity Vehi-
cle center or call 1-800-355-3515.
You can also visit our website
Programming
The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.
1
2
Memory buttons
LED
www.bmwusa.com.<
You can operate the system when the
engine is running or when the ignition is
switched on.
Alternating-code hand-held
transmitter
To program the integrated universal
remote control, consult the Owner's
Manuals for the equipment to be set.
You will find information there on the
possibilities for synchronization.
When programming alternating-code
hand-held transmitters, please follow
the supplementary instructions below:
Fixed-code hand-held transmitter
1.
2.
Switch on the ignition.
For initial use: press both outer
buttons 1 for approx. 20 seconds
until the LED 2 flashes. The three
memory buttons 1 are cleared.
Hold the original hand-held transmit-
ter at a distance of approx. 2 to 8 in/
If the system cannot be operated
after repeated programming,
check whether the original hand-held
transmitter uses an alternating-code
system. To do so, either read the
instructions of the original hand-held
transmitter or press and hold down the
programmed memory button 1 of the
integrated universal remote control.
3.
5
to 20 cm from the memory but-
tons 1.
The required distance between
Programming will be easier with
the hand-held transmitter and
memory buttons 1 depends on the
relevant system of the original hand-
held transmitter used.<
the aid of a second person.<
Online Edition for Part No. 01 41 0 159 867 - © 07/05 BMW AG
| Categories | BMW Manuals, BMW X5 Manuals |
|---|---|
| Tags | BMW E53, BMW X5 3.0i, BMW X5 4.4i, BMW X5 4.8is |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)