tinue to push and hold the HomeLink
button (note steps 2 through 4 under
“Programming HomeLink ”) while you
push and re-push (“cycle”) your hand-
held transmitter every 2 seconds until the
indicator light flashes rapidly (indicating
successful programming).
ț position the hand-held transmitter REPROGRAMMING A SINGLE
with its battery area facing away from HomeLink BUTTON
the HomeLink
surface.
To reprogram a HomeLink
Transceiver button, complete the fol-
lowing.
Universal
ț push and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
1.
Push and hold the desired HomeLink
button. Do not release the button until
step 4 has been completed.
ț position the hand-held transmitter 2
to 5 inches (50 to 127 mm) away from
the HomeLink
transmitter inthat position for up to15
seconds. If HomeLink is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at
all times.
NOTE:
Ifprogramming agarage dooropener, etc.,
it is advised to unplug the device during
the “cycling” process toprevent possible
damage tothegarage dooropener compo-
nents.
surface. Hold the
2.
When the indicator light begins to
flash slowly (after 20 seconds), posi-
tion the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLink
surface.
OPERATING THE HomeLink
UNIVERSAL TRANSCEIVER
3. Push and hold the hand-held trans-
mitter button.
The
HomeLink
Universal Transceiver
Ifyou continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
(once programmed) may now be used to
activate the garage door, etc. To operate,
simply push the appropriate programmed
4. The HomeLink indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
HomeLink
Universal Transceiver button.
The red indicator light will illuminate
while the signal is being transmitted.
The HomeLink Universal Transceiver but-
ton has now been reprogrammed. The
new device can be activated by pushing
the HomeLink button that was just pro-
grammed. This procedure will not affect
any other programmed HomeLink
tons.
CLEARING THE PROGRAMMED
INFORMATION
PROGRAMMING
TROUBLE-DIAGNOSIS
If the HomeLink does not quickly learn
the hand-held transmitter information:
ț replace the hand-held transmitter bat-
teries with new batteries.
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and re-
lease when the indicator light begins to
flash (approximately 20 seconds).
but-
Instrumentsandcontrols 2-49
| Categories | Infiniti G Series Manuals, Infiniti Manuals |
|---|---|
| Tags | Coupe, Infiniti G35 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Automotive readers have rated 2006 Infiniti G35 Coupe Sedan Owners Manual 3.0 out of 3.0 based on 1 product reviews. So far, so good! Shared opinion should be after experience.