2008 Hyundai Getz Owners Manuals

3-
10   WHAT TO DO IN AN EMERGENCY
D060H02A-AAT
7. Re-install Wheel Nuts
D060I01E-GAT
8. Lower  Vehicle  and   Tighten
Nuts
Wheel nut tightening torque:
Steel wheel & aluminium alloy wheel:
900-1,100 kg.cm (65-80 lb.ft)
D060J01FC-GAT
After Changing Wheels
HTB227
To reinstall the wheel cover, hold it on
the studs,  put the wheel  nuts on the
studs  and tighten  them  finger  tight.
The nuts should be installed with their
small diameter ends directed inward.
Jigglethetiretobesureitiscompletely
seated, then tighten the nuts as much
as possible with your fingers again.
HTB150
Lower the car to the ground by turning
the  wheel nut  wrench  counterclock-
wise.Thenpositionthewrenchasshown
in the drawing  and tighten the wheel
nuts.  Be  sure the  socket  is  seated
completely over the nut. Do not stand
on the wrench handle or use an exten-
sion pipe over the wrench handle.
Go around the wheel tightening every
other nut until they are all  tight. Then
double-check each  nut for tightness.
After changing wheels, have a techni-
cian  tighten the  wheel  nuts  to their
proper torque as soon as possible.
HTB151
If you have  a tire gauge, remove the
valve cap and check the air pressure.
If the  pressure is  lower than  recom-
mended, drive  slowly to  the nearest
service station and  inflate to the cor-
rect pressure. If it is too high, adjust it
until it is  correct. Always reinstall the
valve cap after checking  or adjusting
tirepressure.Ifthecapisnotreplaced,
air may leak from the tire. If you lose a
valve cap, buy another and install it as
soon as possible.
Product Specification
Categories Hyundai Manuals, Hyundai Getz Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 383 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Getz
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field