2011 Mercedes-Benz GL350 BlueTEC GL450 GL550 X164 Owners Manual

Stowage areas
276
X Ensure that clamping clawA  sits flush
against the inner edge of roof railF.
If necessary, adjust the span width of the
crossbar (Y page 276).
X Slightly tighten up bolts?  on both sides
in a clockwise direction.
X Tighten up bolts?  on the front and rear
crossbars. Observe the tightening torque of
4
lb/ft (6 Nm) .
G Warning!
?  Bolt for the clamping claw
A  Clamping claw
G  Bolts for adjusting the span width (2 per
side)
Have the tightening torque checked after
mounting the crossbars. The screws could
come loose if they are not tightened to a
torque of 4 lb-ft (6 Nm).
H  Cover strip
X Attach and lock protective caps;.
X Stow the key and Allen key in the stowage
compartment under the cargo
X Pull cover stripH  out of the groove until
boltsG  on both ends of the crossbar are
visible.
X Turn boltsG  on both sides approximately
two turns counterclockwise.
compartment floor again (Y page 274).
Setting the span width of the crossbars
G Warning!
X Align the crossbars on the marked
positions on the roof rails.
Only install the crossbars at the exact
locations designated on the roof rails. The
designated locations for the front crossbars
are between the markings engraved on the
inside of the roof rails. The designated
locations for the rear crossbars are between
the gaps on the roof rails.
X Ensure that clamping clawsA  sit flush
with the roof rails on both sides. If
necessary, pull out or slide into clamping
clawsA.
X Tighten boltsG.  Observe the tightening
torque of 4 lb/ft (6 Nm) .
The width of the clamping claw is not set
correctly.
Otherwise, the crossbars, mounted
accessories and the objects attached to them
could come loose from the vehicle causing an
accident, thereby injuring you and other
persons and/or causing damage to property,
including damage to your vehicle.
G Warning!
Have the tightening torque checked after
mounting the crossbars. The screws could
come loose if they are not tightened to a
torque of 4 lb-ft (6 Nm).
The span width of the crossbars for your
vehicle is set at the factory. The span widths
only fit in the intended positions on the
vehicle.
Only install the crossbars at the marked
positions and observe stickers= FRONT and
REAR.
X Press cover stripH piece by piece into the
groove of the crossbar.
X Install the crossbars as described
(
Y page 274).
Product Specification
CategoriesMercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals
Tags, , ,
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 376 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field