Tire pressures
343
Monitor Active message appears instead
of the tire pressure display. The tire pressures pressures on cold tires. Comply with the tire
conditions (Y page 336). Only correct tire
are already being monitored.
pressures recommended on the Tire and
Loading Information placard on the B-pillar on
the driver's side. Additional tire pressure
values for driving at high speeds or with heavy
loads can be found in the tire pressure table
on the inside of the fuel filler flap.
i If a spare wheel is installed, the system
may continue to show the tire pressure of
the wheel that has been removed for a few
minutes. If this occurs, note that the value
displayed for the position where the
emergency spare wheel/spare wheel is
installed is not the same as the current tire
pressure for the spare wheel.
X Make sure that the tire pressure is set
properly in all four tires.
X Make sure that the key is in position 2 in
the ignition lock.
TPMS warning messages
X Press and hold theV orU button on
the multifunction steering wheel until the
standard display appears in the
multifunction display (Y page 218).
addition, a warning tone sounds and the tire X Press and hold the& or* button
If the TPMS detects a significant pressure
loss on one or more tires, a warning message
is shown in the multifunction display. In
until the tire pressure of all tires or the
Tire pressure displayed after
driving for a few minutes. message
is shown.
X Press the reset button on the instrument
cluster (Y page 28).
pressure warning lamp lights up in the
instrument cluster.
Each tire in which a significant pressure loss
has been detected is highlighted with a red
triangle.
TheRestart tire pressure monitor?
Yes Cancel message appears in the
multifunction display.
X To confirm selection: press theW
button.
TheTire Pressure Monitor
Restarted message appears in the
multifunction display.
After driving for a few minutes, the system
confirms that the current tire pressure
values are within the specified range. The
new tire pressure values are then accepted
as reference values and monitored.
Restarting the tire pressure monitoring
system
G Warning
It is the driver's responsibility to set the tire
inflation pressure to the recommended cold
tire inflation pressure. Underinflated tires
affect the ability to steer or brake the vehicle.
You might lose control over the vehicle.
When you restart the TPMS, all existing
warning messages are deleted and the
warning lamps go out. The currently set tire
pressures are adopted as the specified values
for monitoring.
X To cancel restart: press theX button.
The TPMS must be restarted when you set the
tire pressure to a new value (as a result of
changed handling or load characteristics, for
example). The TPMS then monitors the new
tire pressure values.
Restart the TPMS after the tire pressure has
been set, as desired, according to the
recommended values for the driving
i If the positions of the wheels on the
vehicle have been changed, the tire
pressure may be shown in the wrong
position briefly. This will be corrected after
driving for a few minutes and the tire
pressure will be displayed in the correct
position.
Z
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL350 BlueTEC, Mercedes-Benz GL450, Mercedes-Benz GL550, Mercedes-Benz X164 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)