Features
291
from the transmitter button that you are
programming. Try different angles from a
distance of 2 to 12 inches (5 to 30 cm) or
the same angle from differing distances.
RIf there is another garage door remote
control for the same device, perform the
programming steps again using the remote
control. Before performing these steps,
make sure that new batteries have been
installed in the garage door remote control.
Clearing the remote control memory
X Turn the SmartKey to position 2 in the
ignition lock.
X Press and hold transmitter buttons;
and? for approximately 20 seconds until
indicator lamp: flashes rapidly.
The memory is cleared.
i You should clear the remote control
memory before selling the vehicle.
RAlign the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.
Compass
X To call up the compass: press theV
orU button on the multifunction
steering wheel repeatedly until the off-road
menu appears in the multifunction display.
The compass indicates the direction in
which the vehicle is currently driving:N,NE,
E,SE,S,SW,W orNW.
Opening or closing the garage door
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.
X Turn the SmartKey to position 2 in the
ignition lock.
X Press transmitter button;,= or? in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with fixed code:
indicator lamp: lights up continuously.
Garage door system with rolling code:
indicator lamp: flashes briefly and then
lights up for approximately two seconds.
This is repeated for up to 20 seconds.
i If your vehicle is not equipped with the
AIRMATIC package, the multifunction
display only shows the compass.
i The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and
indicator lamp: will flash. Press the
transmitter button again, if necessary.
Floormat on the driver's side
G Warning!
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Z
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL350 BlueTEC, Mercedes-Benz GL450, Mercedes-Benz GL550, Mercedes-Benz X164 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)