Driving
150
i When you insert Start/Stop button:
switched on, check it and replace it if
into ignition lock;, the system requires a necessary. If an indicator lamp does not go
out after the engine is started or if it lights up
while the vehicle is in motion, see
detection time of two seconds before you
can use Start/Stop button:.
(
Y page 236).
X Shift the transmission to position P.
X Do not press the brake pedal.
Starting the engine
Important safety instructions
G Warning
Inhalation of exhaust gas is hazardous to your
health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.
Do not run the engine in confined areas (such
as a garage) which are not properly ventilated.
If you think that exhaust gas fumes are
entering the vehicle while driving, have the
cause determined and corrected
immediately. If you must drive under these
conditions, drive only with at least one
window fully open at all times.
Start/Stop button
= USA only
? Canada only
X Position 0: if Start/Stop button: has not
yet been pressed, this corresponds to the
SmartKey being removed from the ignition.
X Position 1: press Start/Stop button:.
You can now activate the windshield
wipers, for example.
!
Do not depress the accelerator pedal
when starting the engine.
Automatic transmission
i If you then open the driver's door when in X Shift the transmission to position P.
this position, the power supply is
deactivated.
i The transmission position display in the
multifunction display shows P.
X Position 2 (ignition): press Start/Stop
button: twice.
Starting procedure with the SmartKey
i If you press Start/Stop button: once
when in this position and the driver's door
is open, the power supply is deactivated
again.
X To start a gasoline engine: turn the
SmartKey to position 3 in the ignition lock
(
Y page 149) and release it as soon as the
engine is running.
As soon as the ignition is switched on, all the X To start a diesel engine: turn the
indicator lights in the instrument cluster light
up. The indicator lamps of the low-beam
headlamps, high-beam headlamps or the turn
signal lamps only light up if the low-beam
headlamps, high-beam headlamps or turn
signal lamps are switched on. If an indicator
lamp does not light up when the ignition is
SmartKey to position 2 in the ignition lock
(Y page 149).
The
% preglow indicator lamp in the
instrument cluster lights up.
X When the% preglow indicator lamp
goes out, turn the SmartKey to position 3
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)