Features
274
i To achieve the best result, insert new
batteries in garage door remote control
A of your garage door drive before
programming.
If indicator lamp: goes out after
approximately 20 seconds and has not
flashed rapidly:
X Release transmitter buttons;,= or?
X Erase the memory of the integrated remote
control (Y page 275) before programming
it for the first time.
on the integrated remote control and
transmitter buttonB on the garage door
remote control.
X Turn the key to position 2 in the ignition
lock.
X Press and hold one of transmitter
buttons; to? on the integrated remote
control.
X Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.
After a short time, indicator lamp: will
start flashing. It flashes about once per
second.
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
i Indicator lamp: flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp: will only start flashing at a rate of
once per second after 20 seconds have
elapsed.
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
X Keep the transmitter button depressed.
X Point transmitter buttonB of garage door
remote controlA towards the transmitter
buttons on the rear-view mirror at a
distance of 2 to 12 inches (5 to 20 cm).
Notes on programming the remote
control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals a few seconds after broadcasting.
Therefore, these signals may not last long
i The distance between garage door
remote controlA and the integrated
garage door opener depends on the system enough for the integrated remote control to
of the garage door drive. You might require recognize the signal during programming.
several attempts. You should test every
position for at least 20 seconds before
trying another position.
Comparable with Canadian law, some U.S.
garage door openers also have a built-in
"interruption".
X Keep transmitter buttonB on garage door If you live in Canada or have difficulties
programming the garage door opener
(regardless of where you live) when using the
programming steps (see above), proceed as
follows:
remote controlA pressed until indicator
lamp: starts to flash rapidly.
The programming has been successful if
indicator lamp: flashes rapidly.
X Release transmitter buttons;,= or?
on the integrated remote control and
transmitter buttonB on the garage door
remote control.
X Press transmitter button (;,= or?) and
hold it down during the following steps until
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)