Features
275
the setup has been completed
successfully.
make sure that new batteries have been
installed in the garage door remote control.
X At the same time, press transmitter button RAlign the antenna cable of the garage door
B of the garage door remote control for
two seconds, then release it for two
seconds, then press it again for two
seconds.
opener unit. This can improve signal
reception/transmission.
Opening or closing the garage door
X Repeat this sequence on transmitter
buttonB of the garage door remote
control until the frequency signal has been
saved.
X If the setup procedure is successful,
indicator lamp: flashes once slowly and
goes out after a few seconds.
X Continue with the other programming
steps (see above).
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.
X Turn the SmartKey to position 2 in the
ignition lock.
X Press transmitter button;,= or? in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with fixed code:
indicator lamp: lights up continuously.
Problems when programming
If you have problems when programming the
integrated remote control, please note the
following:
Garage door system with rolling code:
indicator lamp: flashes briefly and then
lights up for approximately two seconds.
This is repeated for up to 20 seconds.
RCheck the transmitter frequency of garage
door remote controlA (which can usually
be found on the rear of the remote control).
The integrated remote control is
compatible with devices that operate at
frequencies between 280 and 390 MHz.
RReplace the batteries in garage door
remote controlA. This increases the
likelihood of garage door remote
i The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and
indicator lamp: will flash. Press the
transmitter button again, if necessary.
controlA sending a strong and precise
signal to the integrated remote control on
the rear-view mirror.
RWhen programming, hold garage door
remote controlA at varying distances and
angles from the transmitter button which
you are programming. Try different angles
at a distance of 2 to 12 inches (5 to 30 cm)
or the same angle at different distances.
RIf there is another garage door remote
control for the same device, perform the
programming steps again using the remote
control. Before performing these steps,
Clearing the remote control memory
X Turn the SmartKey to position 2 in the
ignition lock.
X Press and hold transmitter buttons;
and? for approximately 20 seconds until
indicator lamp: flashes rapidly.
The memory is cleared.
i You should clear the remote control
memory before selling the vehicle.
Z
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)