WHAT TO DO IN AN EMERGENCY
D060H01A-AAT
D060I01A-GAT
7.
Re-install Wheel Nuts
8. Lower Vehlcle and Tighten Nuts
WARNING:
Wheel covers may have sharp edges. Han-
dle them carefully to avoid possible severe
injury.
To re-install the wheel cover, hold it on the
wheel and put the wheel nuts on the studs and
tighten them finger tight. The nuts should be
installed with their small diameterends directed
inward. Jiggle the tire to be sure it is completely
seated, then tighten the nuts with your fingers
again.
Lower the carto the ground by tuming the jack
handle counterclockwise. Then position the
wrenchasshowninthedrawingandtightenthe
wheel nuts. Be sure the socketis seated com-
pletelyoverthe nut. do notstand on the wrench
or use an extension pipe over the wrench
handle.
Go around thewheeltightening every other unt
until they are all tight. Then double-check each
nutfor tightness. After changing wheels, have a
technician tighten the wheel nuts to their proper
torque as soon as possible.
Before putting the wheel into place, be sure
that there is nothing on the hub or wheel
(such as mud, tar, gravel, etc.) that Inter-
feres wlth the wheel fitting solldly agalnst
the hub. If there Is, remove It. If there is not
good contact on the mountlng surface be-
tween the wheel and hub, the wheel nuts
could come loose and cause the loss of a
wheel. Loss of a wheel may result In loss of
control of the vehlcle. This may cause seri-
ous injury or death.
Wheel nut tightening torque:
Steelwheel & aluminium alloywheel:
900-1,100kg.cm(65-80Ib.ft)
3-6
Downloaded from www.Manualslib.com manuals search engine
| Categories | Hyundai Manuals, Hyundai Accent Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Accent |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)