CORROSION PREVENTION AND APPEARANCE CARE
E020C01A-AAT
Keep Your Garage Dry
E030A01A-AAT
WASHING AND WAXING
To clean whitewall tires, use a stiff brush or
soap-impregnated steel-wool scouring pad.
Don't park your car in a damp, poorly ventilated
garage. This creates a favorable environment
for corrosion. This is particulariy true if you
wash your car in the garage or drive it into the
garage when it is still wet or covered with snow,
ice or mud. Even a heated garage can contrib-
ute to corrosion unless it is well ventilated so
moisture is dispersed.
Washlng Your Hyundai
To clean plastic wheel covers, use a clean
sponge or soft cloth and water.
Never wash your car when the surface is hot
from being in the sun. Always wash your car in
the shade.
To clean cast aluminum alloy wheels, use a
mild soap or neutral detergent. Do not use
abrasive cleaners. Protect the bare-metal sur-
faces by cleaning, polishing and waxing. Be-
cause aluminum is subject to corrosion, be sure
to give aluminum alloy wheels special attention
in winter. If you drive on salted roads, clean the
wheels thoroughly afterwards.
Wash your car frequently. Dirt is abrasive and
can scratch the paint if it is not removed. Air
ppllution or acid rain may damage the paint and
trim through chemical action if pollutants are
allowed to remain in contact with the surface. If
you live near the ocean or in an area where
road salts or dust control chemicals are used,
you should pay particular attention to the under-
side of the car. Start by rinsing the car to
remove dust and loose dirt. In winter, or if you
have driven through mud or muddy water, be
sure to thoroughly clean the underside as well.
Use a hard direct stream of water to remove
accumulations of mud or corrosive materials.
Use a good quality car-washing solution and
follow the manufacturer's directions on the pack-
age. These are available at your Hyundai deal-
er or auto parts outlet. Don't use strong house-
hold detergents, gasoline, strong solvents or
abrasive cleaning powders as these may dam-
age the finish.
E020D01A-AAT
Keep Paint and Trim in Good Condition
Scratches or chips in the finish should be cov-
ered with "touch-up" paint as soon as possible
to reduce the possibility of corrosion. If bare
metal is showing through, the attention of a
qualified body and paint shop is recommended.
After washing, be sure to rinse thoroughly. If
soapy water dries on the finish, streaking will
result.
When the weather is warm and the humidity
low, you may find it necessary to rinse each
section immediately after washing to avoid
streaking.
E020E01A-AAT
Don't Neglect the Interior
Moisture can collect under the floor mats and
carpeting to cause corrosion. Check under the
mats periodically to be sure the carpeting is dry.
Use partJcular care if you carry f ertilizers, clean-
ing materials or chemicals in the car.
These should be carried only in proper contain-
ers and any spills or leaks should be cleaned
up, flushed with clear water and thoroughly
dried.
After rinsing, dry the car using a damp chamois
or soft, absorbent cloth. The reason for drying
the car Is to remove water from the car so it will
dry without water spots. Don't rub, this can
damage the finish.
Use a clean sponge or cloth, rinse it frequently
and don't damage the finish by rubbing too
hard. For stubbom spots, dampen them fre-
quently and remove them a little at a time.
If you find any nicks or scratches in the paint,
use touch-up paint to cover them to prevent
corrosion. To protect the paintwork of the car
against corrosion, you must clean your Hyundai
4-2
Downloaded from www.Manualslib.com manuals search engine
| Categories | Hyundai Manuals, Hyundai Accent Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Accent |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)