CONTROLS AND EQUIPMENT
However, in the event of rapid deceleration or
impact, the belt mechanism will automatically
lock.
This could result of death, serious injury or
property damage. Both arms should not be
under or over the belt. Rather, one should be
over and the other under, as shown in the
illustration.
ZB090W2-A
SEAT BELTS (2-Point Static Type)
(Rear Seat Centre)
The mechanism will also lock if the seat belt
webbing is withdrawn too quickly when the
belt is being fastened or if attempts are made
to withdraw the webbing whilst the vehicle is
not on level ground. Should the seat belt lock
under these conditions, it will be possible to
release the mechanism by allowing a small
amount of webbing to be retracted and the
belt withdrawn again.
To Fasten Your Seat Belt
Never wear the seat belt under the arm near-
est the door.
SB090R1-F
To Release the Seat Belt
B200A01S-GAT
SSD1090S
Adjusting Your Seat Belt
To fasten a 2-point static type seat belt, insert
the metal tab into the locking buckle. There
will be an audible "click" when the tab locks
into the buckle. Check to make sure the belt
is properly locked and that the belt is not
twisted.
SSD1090R
The seat belt is released by pressing the
release button in the locking buckle.
When it is released, the belt should automati-
cally draw back into the retractor.
If this does not happen, check the belt to be
sure it is not twisted, then try again.
SSD1090Q
You should place the belt as low as possible
on your hips, not on your waist. If the belt is
located too high on your body, you could slide
under it in case of accident or a sudden stop.
1-
15
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)