DO-IT-YOURSELFMAINTENANCE
6
CHANGING THE OIL AND FILTER
9
G040A04FC-GAT
Gasoline engine
The procedure for changing the oil
and filter is as follows:
4. When the oil has stopped draining,
replace the drain plug using a new
washer and retighten by turning it
clockwise.
Oil filler
cap
1.6
DOHC
1. Park the car on level ground and
set the parking brake. Start the
engine and let it warm up until the
needle on the coolant temperature
gauge moves above the lowest
mark. Turn the engine off and place
the gear selector lever in "P" (auto-
matic) or reverse gear (manual
transaxle).
Oil pan drain plug tightening
torque :
kgf.m
E.C
4.0 ~ 4.5
3.5 ~ 4.5
1.6
DOHC
Except E.C
Oil filler
Drain plug
1.8 DOHC
4.0 ~ 4.5
2.
Open the hood and remove the
engine oil filler cap.
F040A02TB
5. Remove the oil filter by turning it
counterclockwise with a oil filter
wrench of the proper size. A cer-
tain amount of oil will come out
when you remove the filter. So be
sure to have your drain pan in
place underneath it.
6. Install a new oil filter in accordance
with the instructions on the carton
or on the filter itself. Do not over-
tighten.
Oil filler cap
3. Slide underneath the car and loosen
the oil pan drain plug by turning it
counterclockwise with a wrench of
the proper size. Be sure that a
drain pan is in position to catch the
oil as it drains out, then remove the
drain plug.
1.8
DOHC
!
Drain plug
Oil filler
WARNING:
G040A03E
Oil filter tightening torque:
1.2~1.6kgf.m
Be very careful when draining the
engine oil as it may be hot enough
to burn you!
The engine oil and filter should be
changed at those intervals specified
in the maintenance schedule in Sec-
tion 5. If the car is being driven in
severe conditions, more frequent oil
and filter changes are required.
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)