CONTROLS AND EQUIPMENT
If the child seat moves, readjust the length of
the seat belt. Then, if equipped, insert the child
restraint tether strap hook into the child re-
straint hook holder and tighten to secure the
seat. Always refer to the child restraint sys-
tem manufacturer’s recommendation before
installing the child restraint system in your
vehicle.
move it in all directions to be sure the child
restraint system is securely installed.
If you need to tighten the belt, pull more
webbing toward the retractor. When you un-
buckle the seat belt and allow it to retract, the
retractor will automatically revert back to its
normal seated passenger emergency locking
usage condition.
B230B02A-GAT
Using a Child Restraint System with
"Tether Anchorage"System
Cover, Child Restraint
Hook Holder (4 door only)
Bolt, Holder (5/16"-30 mm)
NOTE:
Washer, Conical Spring
B230G01A-GAT
o
Before installing the child restraint
system, read the instructions supplied
by the child restraint system manufac-
turer.
Installation on Outboard Rear Seats
Holder, Child Restraint Hook
On outboard
rear seats
Spacer (10 mm), Child Restraint
Hook Holder
Retainer Washer
o
If the seat belt does not operate as
described, have the system checked
B230B01FC
immediately by
authorised repairer.
your
Hyundai
For small children and babies, the use of a
child seat or infant seat is strongly recom-
mended. This child seat or infant seat should
be of appropriate size for the child and should
WARNING:
Do not install any child restraint system in
the front passenger seat. Should an acci-
dent occur and cause the passenger side
airbag to deploy, it could severely injure
or kill an infant or child seated in an infant
or child seat. Therefore, only use a child
restraint system in the rear seat of your
vehicle.
be
installed in accordance with the
manufacturer's instructions. It is further rec-
ommended that the seat be placed in the
vehicle's rear seat since this can make an
important contribution to safety. Your vehicle
is provided three child restraint hook holders
for installing the child seat or infant seat.
YR10400B
To install a child restraint system in the
outboard rear seats, extend the shoulder/lap
belt from its retractor. Install the child restraint
system, buckle the seat belt and allow the
seat belt to take up any slack. Make sure that
the lap portion of the belt is tight around the
child restraint system and the shoulder por-
tion of the belt is positioned so that it cannot
interfere with the child's head or neck. After
installation of the child restraint system, try to
1-
19
| Categories | Â Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)