If the device fails to function even after
repeated programming, check whether
Deleting stored programs
Press the left and right-hand memory button 1
for approx. 20 seconds until the LED 2 flashes.
All stored programs are deleted.
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button 1 of the integrated universal remote
control. If the LED 2 on the integrated universal
remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons 1 as described at Alternating-code
hand-held transmitters.<
Programs cannot be deleted individually.
Glove compartment
Opening
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:
Press the button. The glove compartment
opens automatically and the lamps come on.
To prevent injury in the event of an acci-
dent while the vehicle is being driven,
close the glove compartment immediately after
use.<
Programming will be easier with the aid of
a second person.<
Closing
1.
2.
Park your vehicle within the range of the
remote-controlled equipment.
Fold the cover up.
Program the integrated universal remote
control as described above in Fixed-code
hand-held transmitters.
Rechargeable flashlight*
The flashlight is located on the left side of the
glove compartment.
3.
4.
Locate the button on the receiver of the
device to be set, e.g. on the drive unit.
The flashlight can remain there continuously.
Remove the flashlight from the socket when
needed.
Press the button on the receiver of the
equipment to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button 1
of the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any additional questions,
please contact your BMW center.<
106
Online Edition for Part no. 01 41 0 013 314 - © 02/07 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 645Ci, BMW E63, BMW E64, BMW M6 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)