4.
5.
Screw dust cap off valve of defective wheel
and screw filling hose 2 of sealant bottle
onto valve.
Producing tire inflation pressure
1.
2.
3.
4.
After approx. 2 miles/3 km, stop at suitable
location.
Insert sealant bottle on compressor hous-
ing so that it is positioned upright.
Screw compressor hose 9 directly onto tire
valve.
Insert connector 3 in lighter socket in vehi-
cle interior.
Correct tire inflation pressure to 29 psi/
200
kPa. With the ignition switched on:
>
Increase inflation pressure: switch on
device, position I. To check currently set
inflation pressure, briefly switch off
device.
Do not allow compressor to run
longer than 10 minutes, otherwise
the device will overheat and may be dam-
6.
7.
8.
Make sure that device is switched off, posi-
tion 0.
Insert connector 3 into lighter socket in
vehicle interior, refer to page 108.
aged.<
>
Reduce inflation pressure: press but-
ton 8 or turn screw 8 on pressure gauge.
With the ignition switched on, refer to
page 58:
Switch on the device and allow to run for
approx. 3 minutes to fill wheel with sealant.
It is not important what inflation pressure
the tire has after filling.
If the inflation pressure is not held, drive
the vehicle again, refer to Distributing
sealant. Then repeat steps 1 to 4 once.
Using the M Mobility System can be ineffective
with tire damage from a size of approx. 0.16 in/
4 mm. Please contact the nearest BMW center,
refer to page 220, or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel if the tire can-
not be made ready for driving with the
M Mobility System.<
9.
Switch off device.
10.
Remove connecting hose from connection
of sealant bottle and tire valve.
Stow the M Mobility System in the vehicle
again.
Distributing sealant
The tire inflation pressure must be at least
29
tinue driving.<
psi/200 kPa. Otherwise, do not con-
Immediately drive approx. 2 miles/3 km so that
sealant is evenly distributed in tire.
Do not exceed a maximum speed of
Continue driving
35
mph/60 km/h. Do not drop below
Do not exceed the permissible maximum
speed of 50 mph/80 km/h, otherwise
accidents can occur.<
12
mph/20 km/h if possible.<
Reinitialize the Flat Tire Monitor.
For details, refer to page 85.
Have the defective tire and the sealant bottle of
the M Mobility System replaced as soon as
possible.<
214
Online Edition for Part no. 01 41 0 013 314 - © 02/07 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 645Ci, BMW E63, BMW E64, BMW M6 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)