IN CASE OF EMERGENCY
3
9
SD070G1-E
5. Raising the Car
D060G02Y-EAT
6. Changing Wheels
!
WARNING:
Do not get under the car when it is
supported by the jack! The jack is
solely designed for wheel chang-
ing and is not intended to support
the vehicle for other purposes. The
use of purpose designed supports
is necessary whilst the vehicle is
raised and the operator is required
to get underneath.
Wrench bar
Wheel nut wrench
D060F01MC
OGK036403
After inserting a wrench bar into the
wheel nut wrench, install the wrench
bar into the jack as shown in the draw-
ing. As the jack begins to raise the
vehicle,doublecheckthatitisproperly
positioned and will not slip. If the jack
is on soft ground or sand, it may be
necessary to place a stout piece of
timber under the base of the jack to
prevent it from sinking.
Loosen the wheel nuts and remove
them with your fingers. slide the wheel
off the studs and lay it flat so it cannot
rollaway. Toputthewheelonthehub,
pickupthesparetyre,lineuptheholes
with the studs and slide the wheel onto
them. If this is difficult, tip the wheel
slightly and get the top hole in the
wheel lined up with the top stud. Then
jigglethewheelbackandforthuntilthe
wheel can be slid over the other studs.
Raise the car high enough so that the
fully inflated spare tyre can be in-
stalled.
| Categories | Hyundai Manuals, Hyundai Coupe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Coupe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)