3-
10 WHAT TO DO IN AN EMERGENCY
D060H02A-AAT
7. Re-install Wheel Nuts
D060I01E-GAT
8. Lower Vehicle and Tighten
Nuts
Wheel nut tightening torque:
Steel wheel & aluminium alloy wheel:
900-1,100 kg.cm (65-80 lb.ft)
D060J01FC-GAT
After Changing Wheels
HTB227
To reinstall the wheel cover, hold it on
the studs, put the wheel nuts on the
studs and tighten them finger tight.
The nuts should be installed with their
small diameter ends directed inward.
Jigglethetiretobesureitiscompletely
seated, then tighten the nuts as much
as possible with your fingers again.
HTB150
Lower the car to the ground by turning
the wheel nut wrench counterclock-
wise.Thenpositionthewrenchasshown
in the drawing and tighten the wheel
nuts. Be sure the socket is seated
completely over the nut. Do not stand
on the wrench handle or use an exten-
sion pipe over the wrench handle.
Go around the wheel tightening every
other nut until they are all tight. Then
double-check each nut for tightness.
After changing wheels, have a techni-
cian tighten the wheel nuts to their
proper torque as soon as possible.
HTB151
If you have a tire gauge, remove the
valve cap and check the air pressure.
If the pressure is lower than recom-
mended, drive slowly to the nearest
service station and inflate to the cor-
rect pressure. If it is too high, adjust it
until it is correct. Always reinstall the
valve cap after checking or adjusting
tirepressure.Ifthecapisnotreplaced,
air may leak from the tire. If you lose a
valve cap, buy another and install it as
soon as possible.
| Categories | Hyundai Manuals, Hyundai Getz Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Getz |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)