5.
Insert the sealant bottle into the housing of
the compressor so that the bottle is upright.
3
Connector and cable for the cigarette
lighter socket
4
5
6
7
Holder for the sealant bottle
Compressor
6.
7.
Ensure that the compressor is switched off,
position 0.
Insert connector 3 into the cigarette lighter
socket in the interior of the vehicle, refer to
page 108.
On/off switch
Pressure gauge for displaying the tire infla-
tion pressure
8.
With the ignition switched on:
8
9
Screw on pressure gauge to reduce tire
inflation pressure
Switch on the compressor and let it run for
approx. 3 minutes to fill the sealant. The
inflation pressure of the tire after filling is
unimportant.
Hose to connect compressor and sealant
bottle or compressor and wheel
The connector, cable and connection hose are
stored in the compressor housing.
9.
Switch off the compressor.
10.
Detach the hoses from the sealant bottle
connector and from the tire valve.
Return the M Mobility System to its storage
location in the vehicle.
Using the M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
Distributing the sealant
>
>
>
Fill the sealant, refer to page 227.
Distribute the sealant, refer to page 227.
Immediately drive approx. 2 miles/3 km to
evenly distribute the sealant in the tire.
Produce the tire inflation pressure, refer to
page 227.
Do not exceed a speed of 35 mph/
60
km/h. If possible, do not fall below a
Filling the sealant
speed of 12 mph/20 km/h.<
Strictly follow the specified sequence,
otherwise the sealant may escape under
Producing the tire inflation pressure
high pressure.<
1.
2.
3.
After driving approx. 2 miles/3 km, stop at a
suitable location.
1.
2.
Shake the sealant bottle.
Connect connection hose 9 of the com-
pressor directly to the tire valve.
Screw connection hose 9 onto the connec-
tor of the sealant bottle.
Insert connector 3 into the cigarette lighter
socket in the interior of the vehicle.
3.
4.
Ensure that screw 8 on the pressure gauge
is closed.
Unscrew the dust cap from the valve of the
defective wheel and screw filling hose 2 of
the sealant bottle onto the valve.
227
Online Edition for Part no. 01 41 0 014 958 - © 02/08 BMW AG
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E92, BMW M3 Manuals |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)