4.
Adjust the tire inflation pressure to 29 psi/
Jack mounting points
200
kPa. With the ignition switched on, pro-
ceed as follows:
>
To increase the inflation pressure:
Switch on the compressor, position I. To
check the current inflation pressure set-
ting, briefly switch off the compressor.
Do not let the compressor run for
more than 10 minutes, otherwise the
device will overheat and may be dam-
aged.<
The jacking points are at the positions shown in
the illustration.
>
To reduce the inflation pressure: turn
screw 8 on the pressure gauge.
If the inflation pressure is not maintained,
drive the vehicle a second time, refer to
Vehicle battery
Distributing the sealant. Then repeat steps 1 to
4.
Battery care
Use of the M Mobility System may be ineffec-
tual for tire damage larger than approx. 0.16 in/
The battery is 100% maintenance-free, the
electrolyte will last for the life of the battery
when the vehicle is operated in a temperate cli-
mate. Your BMW center will be glad to advise in
all matters concerning the battery.
4
mm. Please contact the nearest BMW center,
refer to page 230, or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel if the tire can-
not be made roadworthy with the M Mobility
System.<
Charging the battery
Only charge the battery in the vehicle via the
terminals in the engine compartment with the
engine off. Connections, refer to Jump starting
on page 231.
The tire inflation pressure must be at least
29
psi/200 kPa. If it is not, do not continue
driving.<
Continuing your trip
Disposal
Do not exceed the maximum allowable
speed of 50 mph/80 km/h to avoid the risk
of an accident.<
Have old batteries disposed of by your
BMW center or hand them in to a recy-
cling center. Maintain the battery in an upright
position for transport and storage. Always
secure the battery against tipping over during
transport.<
Reinitialize the Flat Tire Monitor, refer to
page 85 for more information.
Have the faulty tire and the sealant bottle of the
M Mobility System replaced as soon as possi-
ble.<
Power failure
After a temporary power loss, the functioning of
some equipment may be limited and require
reinitialization. Individual settings may likewise
have been lost and will have to be programmed:
Changing wheels
The tools for changing wheels are avail-
able as optional accessories from your >
Time and date
These values must be updated, refer to
page 74.
BMW center.<
228
Online Edition for Part no. 01 41 0 014 958 - © 02/08 BMW AG
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E92, BMW M3 Manuals |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)