Do not remove the covers, and never
stare into the unfiltered light for several
hours, as irritation of the retina could result.<
rear, release the snap connection at the
front and take it off the trim strip.
Xenon lamps
The service life of these bulbs is very long and
the probability of a failure is very low, provided
that they are not switched on and off an unusual
number of times.
Have work on the xenon lighting system
performed only by your BMW center or a
workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel. Due to the high voltage present in the
system, there is a danger of fatal injuries when
work is carried out improperly.<
2.
3.
Turn the bulb holder to the left by 905 and
remove.
Remove and replace the bulb.
Tail lamps
Parking lamps, roadside parking
lamps, daytime running lamps
The roadside parking lamps, tail lamps,
brake lamps, and turn signals use LED
technology. The backup lamps are equipped
with long-life bulbs. Please contact a BMW cen-
ter in case of a malfunction.<
The illustration shows the left-hand side of the
engine compartment.
35-watt bulb, H
8
1
2
3
4
Turn signal
1.
Remove the cover cap 1 by pressing the tab
and removing the cover cap upward.
Turn the bulb holder to the left and remove.
Remove and replace the bulb.
Roadside parking, tail and brake lamps
Reflector
2.
3.
Backup lamp
Always wear gloves and eye protection –
the atmosphere inside the H8 bulb is
pressurized. Otherwise there is a danger of inju-
ries if the bulb is accidentally damaged during
replacement.<
Side-mounted turn signals
5-watt bulb, WY5W
1.
Press against the front edge of the lamp
with the tip of your finger, then push it to the
225
Online Edition for Part no. 01 41 2 600 775 - © 08/08 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 650i, BMW E63, BMW E64, BMW M6 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)