the vehicle, and never start the engine while it is
Preparing wheel change
supported by the jack.<
1.
2.
Observe the safety precautions above.
Prevent the vehicle from rolling:
Place the chock behind the front wheel on
the other side of the vehicle, or on inclines,
in front of this wheel. On steeply inclined
roads, always secure the vehicle against
rolling.
What you will need
To avoid rattling noises later on, note the posi-
tions of the tools before removing them, then
return them to their initial positions after com-
pleting work.
3.
Loosen the lug bolts a half turn.
Jacking up vehicle
1
2
3
Chock*
Vehicle jack*
Lug wrench*
The jacking points for the car jack are located in
the positions shown.
The tools are located in the hollow of the spare
wheel.
1.
Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
Spare wheel*
1.
2.
Fold up the convertible top compartment
floor, refer to Convertible: increasing lug-
gage compartment capacity, page 37.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal injury.<
Pull back lock 1, fold open tensioning lock 2
completely and loosen the belt 3.
2.
Guide the jack head into the rectangular
recess of the jacking point when cranking
up, refer to illustration detail.
3.
4.
Remove the cover 4.
Take the tool mounting out of the spare
wheel.
5.
Remove the spare wheel.
3.
Jack the vehicle up until the wheel you are
changing is raised from the ground.
229
Online Edition for Part no. 01 41 2 600 775 - © 08/08 BMW AG
Product Specification
Categories | BMW 6-Series Manuals, BMW Manuals |
---|---|
Tags | BMW 650i, BMW E63, BMW E64, BMW M6 |
Model Year | 2009 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |