Controls in detail
Useful features
Gate operator/Canadian programming
remote control until the frequency signal
has been learned.
Upon successful training, indicator lamp
1 will flash slowly and then rapidly after
several seconds.
X Switch on the ignition.
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission which
may not be long enough for the integrated
X Press and hold the desired signal
transmitter button (2, 3 or 4). Do not
release the button.
Indicator lamp 1 will begin to flash after
20 seconds.
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
signal transmitter to pick up the signal during X Proceed with programming step 5 and
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
step 6 to complete.
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
Operation of integrated remote control
X Switch on the ignition.
X Select and press the appropriate
integrated signal transmitter button (2,
3 or 4) to activate the remote controlled
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
X Step 4: Press and hold the signal
transmitter button (2, 3 or 4). Do not
release this button until it has been
successfully trained.
X While still holding down the signal
transmitter button (2, 3 or 4), “cycle”
your hand-held remote control button 6
as follows: Press and hold button 6 for
Reprogramming a single signal
transmitter button
To program a device using a signal
transmitter button previously trained, follow
these steps:
Erasing the integrated remote control
memory
2
seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons 2 and 4, for
248
| Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz C-Class, Mercedes-Benz C250, Mercedes-Benz C300, Mercedes-Benz C350, Mercedes-Benz C63 AMG, Mercedes-Benz W204 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5)
Automotive readers have rated 2009 Mercedes-Benz C-Class Operators Manual C230 C300 4MATIC C350 Sport C63 AMG 4.5 out of 5.0 based on 4 product reviews. I have the French version and needed English ver. C300 2009.
Thank you
Great review...can't get any better.
PDF is good to have on your phone.
Thank you for share the manual
Thank you for the owners manual, much appreciated.