Controls in detail
Panorama roof with power tilt/sliding panel
Opening
Closing
direction of arrow 3 until the tilt/sliding
panel is fully closed.
X Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow 2.
X Closing manually: Pull and hold the roof
panel switch to the resistance point in
direction of arrow 3.
G Warning!
Pulling and holding the roof panel switch to
close the tilt/sliding panel immediately
after it had been blocked two times will
cause the tilt/sliding panel to close without
any reversal function for as long as you hold
the roof panel switch.
X Release the roof panel switch when the
desired position is reached.
X Release the roof panel switch when the
desired position is reached.
X Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow 2 and release.
Closing when the tilt/sliding panel is
blocked
G Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing the tilt/sliding panel
without automatic reversal function.
X Stopping during Express operation:
Move the roof panel switch in any direction.
Synchronizing
The tilt/sliding panel and roller sunblinds
must be synchronized
i When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
Rafter the battery has been disconnected or
discharged
If the movement of the tilt/sliding panel is
blocked during the closing procedure, the
tilt/sliding panel will stop and open slightly.
Rafter a malfunction
X Immediately after the tilt/sliding panel has
stopped because it was blocked, pull the
roof panel switch in direction of arrow 3
Rif the tilt/sliding panel does not open
smoothly
!
Do not attempt to open or close the tilt/
(
fully closed.
Y page 203) until the tilt/sliding panel is
Raising
sliding panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
X Rasing manually: Press and hold the roof
panel switch to the resistance point in
direction of arrow 1.
If the tilt/sliding panel is blocked again and
opens slightly:
X Immediately after the tilt/sliding panel was
blocked, pull the roof panel switch in
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
X Release the roof panel switch when the
desired position is reached.
Z
205
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)