Controls in detail
Useful features
3
device.
The integrated remote control transmitter RPut a new battery in hand-held remote
continues to send the signal as long as the
button is pressed – up to 20 seconds.
or 4) to activate the remote controlled
control is compatible with radio-frequency
devices operating between 280-390 MHz.
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (in the USA) at
control 5. This will increase the likelihood
of the hand-held remote control sending a
faster and more accurate signal to the
integrated remote control.
1-800-FOR-MERCedes,
or Customer
Service (in Canada) at 1-800-387-0100.
Erasing the integrated remote control
memory
RWhile performing step 3, hold hand-held
remote control 5 at different lengths and
angles from the signal transmitter button
i USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
i If you sell your vehicle, erase the codes of
all three channels.
(
2, 3 or 4) you are programming.
X Switch on the ignition.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
1.
This device may not cause harmful
interference, and
X Simultaneously press and hold outer signal
transmitter buttons 2 and 4, for
approximately 20 seconds, until indicator
lamp 1 flashes rapidly. Do not hold for
longer than 30 seconds.
2. this device must accept any
interference received, including
interference that may cause undesired
operation.
RIf another hand-held remote control is
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
batteries are in the hand-held remote
control before beginning the procedure.
The codes of all three channels are erased.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
Programming tips
RStraighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
i Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
RCheck the frequency of hand-held remote
control 5 (typically located on the reverse
side of the remote). The integrated remote
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
240
| Categories | Mercedes-Benz Manuals, Mercedes-Benz R-Class Manuals |
|---|---|
| Tags | Mercedes Benz R350, Mercedes Benz R350 BlueTEC, Mercedes Benz V251 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)