ENGINE
Distributor - refit
12.
Lubricate new timing cover oil seal with engine
oil.
13.
14.
Fit timing cover oil seal using tool LRT-12-089.
Fit crankshaft pulley, fit bolt and spacer
washer; tighten bolt to correct torque.
1.
2.
3.
Ensure timing pointer is aligned with 30 mark
on crankshaft pulley and No.1 piston is on the
compression stroke.
Engine numbers without suffix B: Position
oil pump drive shaft tongue at the ten to four
position.
Lubricate a new ’O’ ring with engine oil and fit
to distributor.
Sump - refit
1. Remove all traces of old sealant from mating
faces of cylinder block and sump.
2.
Clean mating faces with suitable solvent and
apply a 2 mm bead of Hylosil white silicone
sealant to sump joint face as shown.
Fit sump, taking care not to damage sealant
bead.
Fit sump bolts and working from the centre
outwards, tighten progressively to correct
torque.
3.
4.
4.
5.
Turn distributor drive until rotor arm is
approximately 30° anti-clockwise from No.1
spark plug segment in distributor cap.
Insert distributor into timing cover, engage
drive gear and push distributor down until ’O’
ring enters bore; position distributor clamp on
stud.
5.
6.
Fit and tighten screw securing dipstick tube to
LH rocker cover.
Fit dipstick.
14
OVERHAUL
| Categories | Land Rover, Land Rover Discovery |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | 3.5, 3.9 and 4.2 Litre V8 engines |
| Product Brand | Land Rover |
| Engine Manufacturer | Rover Group |
| Engine Motor Size | 3.5L, 3.9L, 4.2 Litre |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)