CONTROLS AND EQUIPMENT
B230E02FC-DAT
B230C02FC-EAT
SecuringaChildRestraintSystemwith
Using a Child Restraint System with
"Tether Anchorage" System
"ISOFIX" System and "Tether Anchor-
age" System
Three child restraint hook holders are located
on the vertical back panel. (behind rear bumper
bar)
Covering shelf
To install the child restraint seat
1.
Route the child restraint seat strap over
the seatback.
For vehicles with adjustable headrests,
route the tether strap under the headrest
and between the headrest posts, other-
wise route the tether strap over the top of
the seatback.
B230F01FC
Tether straphook
Back panel
ISOFIX is a standardised method of fitting
child seats that eliminates the need to use the
standard adult seat belt to secure the seat in
the vehicle. This enables a much more se-
cure and positive location with the added
benefit of easier and quicker installation.
Front of Vehicle
B230E01FC
An ISOFIX-seat can only be installed if it has
vehicle-specific approval in accordance with
the requirements of ECE-R44. For your
Hyundai, the Hyundai ISOFIX GR1 / Hyundai
Duo / Römer ISOFIX GR1 and the Römer
Duo ISOFIX / Britax Duo ISOFIX is approved
according to the requirement ECE-R44. This
seat has been tested extensively by Hyundai
and is recommended for your Hyundai.
2.
Connect the tether strap hook to the child
restraint seat hook holder and tighten to
secure the seat.
WARNING:
To install the Child Restraint Seat, for
safety reasons the Seat should be posi-
tioned rearmost with the seatback in a
vertical position, not reclined.
1-
19
fcuk-1.p65
19
3/6/2007, 9:58 AM
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)