IN CASE OF EMERGENCY
SD070E1-E
SD070F1-F
SD070G1-E
3
. Loosen Wheel Nuts
4. Put the Jack in Place
5. Raising the Car
Wrench bar
Wheel nut wrench
D060D01FC-D
HFC4022
HFC4006
The wheel nuts should be loosened slightly
before raising the car. To loosen the nuts, turn
the wheel brace counterclockwise. Ensure
that the wheel brace socket is seated properly
on the nut and that it cannot slip. Do not
remove the nuts at this stage.
The base of the jack should be placed on firm,
level ground. The jack should be positioned
as shown in the drawing.
After inserting a wrench bar into the wheel nut
wrench, install the wrench bar into the jack as
shown in the drawing. To raise the vehicle, turn
the wheel nut wrench clockwise. As the jack
begins to raise the vehicle, double check that it
is properly positioned and will not slip. If the jack
is on soft ground or sand, it may be necessary
to place a stout piece of timber under the base
of the jack to prevent it from sinking.
Raise the car high enough so that the fully
inflated spare wheel can be installed.
WARNING:
Do not get under the car when it is support-
ed by the jack! The jack is solely designed
for wheel changing and is not intended to
support the vehicle for other purposes. The
use of purpose designed supports is neces-
sary whilst the vehicle is raised and the
operator is required to get underneath.
3-6
fcuk-3.p65
6
3/6/2007, 9:59 AM
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)