Controls in detail
Useful features
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Operation of integrated remote control
i
If you sell your vehicle, erase the codes
of all three channels.
̈
̈
Switch on the ignition (୴ page 35).
Select and press the appropriate inte-
grated signal transmitter button (2,
Reprogramming a single integrated sig-
nal transmitter button
3
or 4) to activate the remote con-
Step 4:
trolled device.
̈
Continue to press and hold the inte-
grated signal transmitter button (2,
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
3
or 4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter 6 every two seconds
until the frequency signal has bee-
learned. Upon successful training, the
indicator lamp 1 will flash slowly and
then rapidly after several seconds.
20
seconds.
Press and hold the desired signal trans-
mitter button (2, 3 or 4). Do not re-
lease the button.
̈
Erasing the integrated remote control
memory
̈ The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
̈
̈
Switch on the ignition (୴ page 35).
Simultaneously hold down the signal
transmitter buttons 2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp 1 blinks rapidly. Do not
hold for longer than 30 seconds.
̈
Proceed with programming step 5 and
step 6 to complete.
The codes of all three channels are
erased.
210
Product Specification
Categories | Mercedes-Benz G-Class Manuals, Mercedes-Benz Manuals |
---|---|
Tags | Mercedes Benz W463, Mercedes-Benz G500, Mercedes-Benz G55 AMG |
Model Year | 2005 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |