Controls in detail
Useful features
Gate operator/Canadian programming
Step 4:
Erasing the integrated remote control
memory
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
̈ Continue to press and hold the inte-
grated signal transmitter button (1,
2 or 3) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter 6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp 4 will flash slowly and
then rapidly after several seconds.
̈ Switch on the ignition (୴ page 34).
̈
Simultaneously hold down the signal
transmitter buttons 1 and 3, for
approximately 20 seconds, until the
indicator lamp 4 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
If you live in Canada or if you are having dif-
ficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
̈ Proceed with programming step 5 and
step 6 to complete.
i
If you sell your vehicle, erase the codes
of all three channels.
Operation of integrated remote control
̈
̈
Switch on the ignition (୴ page 34).
Select and press the appropriate inte-
grated signal transmitter button (1,
2 or 3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20
seconds.
261
| Categories | Mercedes-Benz CLS-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CLS500, Mercedes-Benz CLS55 AMG, Mercedes-Benz W219 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)