Lights
2.
Install the bulb retaining ring over the plastic base and lock the ring
by rotating clockwise until it snaps into place.
3.
4.
Connect the electrical connector to the bulb.
Install the protective dust shield and lock the shield by rotating it
clockwise until it locks into position.
5.
6.
Carefully position the headlamp assembly onto the vehicle.
Hold the headlamp assembly snugly against the vehicle and install the
retainer pins straight down to lock the lamp into place.
Before reinstalling the bolt, make sure the retainer pins are fully
seated, and install bolt on headlamp housing.
Turn the headlamps on and make sure they work properly. If the
7.
8.
headlamp was correctly aligned before you changed the bulb, you should
not need to align it again.
Replacing front parking lamp/turn signal/cornering lamp bulbs
1.
is in the OFF position and open the
hood.
Make sure the headlamp control
2.
Remove the bolt (1) from the
headlamp housing.
3.
At the back of the headlamp, pry
up and remove the two retainer pins
to release the headlamp assembly
from the vehicle and pull headlamp
forward.
4.
Rotate the bulb socket
counterclockwise and remove it
from the lamp assembly.
37
2007
Taurus (tau)
Owners Guide (post-2002-fmt)
USA (fus)
| Categories | Ford Manuals, Ford Taurus Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)