Lights
Replacing tail/brake/turn signal/backup lamp bulbs
The tail lamp, brake lamp, turn
signal lamp and backup lamp bulbs
are located in the same portion of
the tail lamp assembly. Follow the
same steps to replace any bulb.
1.
Make sure headlamp switch is in
OFF position and open trunk and
remove two plastic mushroom nuts,
five push pins and the plastic cover
from inside the trunk to access the
lamp assembly.
2.
Carefully pull the carpet away to
expose the lamp assembly hardware.
3.
Remove three nut and washer
assemblies and the lamp assembly
from the vehicle.
4.
rotating it counterclockwise, then
pulling it out of the lamp assembly.
Remove the bulb socket by
5.
Pull the bulb from the socket and
push in the new bulb.
6.
Install the bulb socket into the
lamp assembly by rotating it
clockwise.
7.
assemblies ensuring the washers on the nuts are flush with the body to
prevent water from entering the trunk.
Install the lamp assembly on the vehicle with three nut and washer
8.
Carefully push the carpet back in to place and install the plastic cover
inside the trunk with five push pins and two plastic mushroom nuts.
40
2007
Taurus (tau)
Owners Guide (post-2002-fmt)
USA (fus)
| Categories | Ford Manuals, Ford Taurus Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)